Eliminate Silt Build-Up

Stop paying those costly repair bills due to silt build-up and clogging. Finally, there is a product that can eliminate silt build-up in your MerCruiser, Volvo Penta, Indmar or PCM engine.

Typically, silt build-up starts at the low points and cavities of your engines water passages. This also tends to be the locations of your engines drain points. Even if you tried to remove the drain plugs and flush out your engine the old fashioned way, your drains were probably clogged with silt. Not anymore.

That old drain plug is replaced with our block and hose fittings that all connect to the Minute Drain flushing drain valve. This allows you to flush each section of the engine's water system one at a time by a simple turn of the valve.

Silt Removal Directions

• Run the engine while the boat is in the water.
• Open each valve for 5 seconds then close.
  (This will flush silt from each engine area)
• Turn on bilge pump and pump water overboard.